Replacing rear ride height sensor (Cooper)

Removal: 

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Slacken nut (4).

Detach the jointed rod on the lever of the sensor. Release screw (2).

Remove ride height sensor (3).

Unscrew the screws (1).

Take off holder (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Courtesy of BMW OF NORTH AMERICA, INC.

Position holder (2) on ride height sensor.

Tighten down screws (1).

Tightening torque 37 14 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Position ride height sensor (3) with holder on rear axle support.

Tighten screw (2).

Tightening torque 37 14 3AZ .

Connect plug connection (1).

Attach the jointed rod on the lever of the sensor.

Tighten nut (4).

Tightening torque 37 14 4AZ .

Required follow-up work: 

• Check HEADLIGHT ADJUSTMENT , correct if necessary.