REPAIR PART 1 OF 3 - Clean faulty areas
WARNING: This page is about a different car, the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
A partially released bonding (rubber component, adhesive tape or adhesive tape paint) up to 120 mm may be finished.
A partially released bonding (rubber component, adhesive tape or adhesive tape paint) above 120 mm may not be finished. Gasket must be replaced.
- Release adhesive area of paint side from recesses and degrease with CLEANING AGENT R2 . Stick to air drying time > of 1 minute. Never use paint thinner.
- This will usually partially destroy intact edge adhesive areas.
- When removing, it is important to wipe off the adhesive area of the adhesive tape with a lint-free disposable cloth. (e.g. blue Kimtex)
- Carefully wipe off the adhesive areas.
Use necessary cotton- or fluff-free paper towel once only.
Do not touch the adhesive area after cleaning.