Procedure for vehicles with active pedestrian protection after an accident
WARNING: This page is about a different car, the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
The AFGS system consists of the following components:
- Satellites (control unit + sensor)
- Sensors, inside, bumper cover, left/center/right
- ACSM control unit (Crash Safety Module)
- Cables and connectors
- Engine compartment lid hinges
- actuator
- Hood hinge
In case of a frontal crash or side collision in the area of the hood and/or the A-pillars, check the following components:
Satellites (control unit + sensor)
- Procedure
- Read fault memory.
- Disconnect the vehicle battery and observe the waiting period.
- Rectify fault.
- Reconnect the vehicle battery and observe the waiting period.
- Delete the fault memory.
- Switch off ignition and wait at least 2 minutes (no consumers, such as such as e.g. interior light, radio, etc., may be switched on during this period).
- Switch the ignition on.
- Read fault memory and rectify faults if necessary.
Cables and connectors
- Procedure
- Check cables and connectors for damage, replace if necessary.
Procedure with activation of active pedestrian protection:
Engine compartment lid hinges
- Replace ACTUATORS .
- CHECK BOTH HOOD HINGES . Replace damaged hinges.
If necessary, repair hinges with repair kit.
If no repair kit is available, the hinge must be replaced.
| Model | Repair kit available |
| F15, F16 | No |
| F20, F21, F22, F23, F32, F33, F34, F36, F80, F82, F83, F87 | Yes |
| F55, F56, F57, F60 | No |
| F45, F46, F48, F49 | No |
Procedure without activation of active pedestrian protection:
Engine compartment lid hinges
- Check BOTH HOOD HINGES and replace if necessary.
- If the hinge is damaged, the ACTUATOR must also be replaced.