11 22 513 Replacing roller bearing for dual-mass flywheel (vehicles with manual transmission)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

21 2 050

Necessary preliminary tasks:

Remove FLYWHEEL

Using a hydraulic press (1) and special tool 21 2 050 /21 2 051 , press the roller bearing out of the dual-mass flywheel downwards on engine side.

IMPORTANT:

Risk of damage:

Roller bearing must not be driven out.

Fig 1: Pressing Roller Bearing Out Of Dual-Mass Flywheel Downwards On Engine Side

Courtesy of BMW OF NORTH AMERICA, INC.

Push the roller bearing (2) onto special tool 21 2 050 /21 2 052 .

Using hydraulic press (1), press roller bearing into dual-mass flywheel to limit position on clutch side.

IMPORTANT:

Risk of damage.

Observe press-in instructions:

Roller bearing must not be driven in.
Roller bearing mounting force/travel
monitored:

Min. 2000 N 1 mm before end of pressing in.

Max. 15.000 N during entire press-in procedure.

Fig 2: Pressing Roller Bearing Into Dual-Mass Flywheel To Limit Position On Clutch Side

Courtesy of BMW OF NORTH AMERICA, INC.