37 14 512 Replacing rear ride height sensor

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Attention !

Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Removal:

Disconnect plug connection (1).

Slacken nut (4).

Detach the jointed rod on the lever of the sensor.

Release screw (2).

Fig 1: Ride Height Sensor, Plug Connection And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Remove ride height sensor (3).

Fig 2: Ride Height Sensor Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Take off holder (2).

Installation:

Position holder (2) on ride height sensor.

Tighten down screws (1).

Tightening torque 37 14 1AZ .

Fig 3: Ride Height Sensor Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 4: Ride Height Sensor, Plug Connection And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Position ride height sensor (i) with holder on rear axle support.

Tighten screw (2).

Tightening torque 37 14 3AZ .

Connect plug connection (1).

Attach the jointed rod on the lever of the sensor.

Tighten nut (4).

Tightening torque 37 14 4AZ .

Required follow-up work:

Check HEADLIGHT ADJUSTMENT , correct if necessary.