37 12 400 Remove and install support bearing for shock absorber (EDC), rear

Special tools required: 

• 33 0 040

Necessary preliminary tasks: 

• Remove REAR SHOCK ABSORBER .

Removal: 

Release adapter plate (2) from support bearing.

Fig 1: Adapter Plate And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect connector (1) from shock absorber.

Remove adapter plate (2).

Fig 2: Releasing Nut With Special Tool (33 0 040)

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) with special tool 33 0 040 , reversible ratchet with extension and socket SW10.

Remove spring strut mounting (2).

Impact screwdrivers are prohibited!

Risk of damage inside the shock absorber  !

Installation: 

Fig 3: Tightening Down Nut With Special Tool (33 0 040)

Courtesy of BMW OF NORTH AMERICA, INC.

Fit support bearing (2).

Part:  Replace nut (1).

Tighten down nut (1) with special tool 33 0 040 , reversible ratchet with extension, socket SW10 and torque wrench with ring spanner attachment SW21.

Tightening torque 33 52 3AZ .

Impact screwdrivers are prohibited!

Risk of damage inside the shock absorber  !

Fig 4: Cable Routing Correct Position

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Make sure cable routing (1) is in the correct position. See illustration.

Connect connector (1) to shock absorber.

Fig 5: Adapter Plate And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Fit adapter plate (2) on support bearing and engage.