32 00 620 Adjusting rear axle
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required :
NOTE:
A camber change always means a toe change as well. The camber must therefore be adjusted first.
If camber and toe-in are not adjustable within setpoint range: Troubleshooting at rear axle.
If camber and toe-in are not adjustable within setpoint range: Troubleshooting at rear axle.
Adjusting camber :
Renew the eccentric bolt (1) and nut and tighten to 5 Nm prior to setting.
Turn screw (1) and adjust camber to setpoint value.
Tighten nut (1).
Parts : Renew nut.
Tightening torque 33 32 2AZ .
Adjusting toe :
Renew the screws (1) and (2) and tighten to 5 Nm prior to setting.
Mount special tool 32 4 200 on screw (2).
Turn special tool 32 4 200 and adjust toe-in to setpoint value.
Tighten down screws (1).
Tightening torque 33 32 5AZ .