LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2019 >> Cooper Clubman S ALL4, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Heating And Air Conditioning - Repair (F55, F56)) >> HVAC Unit, Control Panel, Blowers, HVAC Sensors, Blending Flap Actuator >> 64 11 208 Replace heat exchanger

64 11 208 Replace heat exchanger

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks: 

Removal: 

Loosen screw (1).

Unlock latch mechanisms (2 and 3).

Remove cover (4).

Fig 1: Cover, Latch Mechanisms, And Screw
G11149039Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Take off holder (2).

Pull the heat exchanger for the heating system (3) out of the heating and air-conditioning unit (4).

Fig 2: Holder, Screw, Heat Exchanger, And Heating/Air-Conditioning Unit
G11149040Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Position cover (4) correctly.

Lock latch mechanisms (2 and 3).

Tighten screw (1).

Fig 3: Cover, Latch Mechanisms, And Screw
G11149039Courtesy of BMW OF NORTH AMERICA, INC.

Slide the heat exchanger for the heating system (3) into the heating and air-conditioning unit (4).

Position holder (2) correctly.

Tighten screw (1).

Fig 4: Holder, Screw, Heat Exchanger, And Heating/Air-Conditioning Unit
G11149040Courtesy of BMW OF NORTH AMERICA, INC.