Removing and installing complete bearing bracket for foot pedal (Cooper)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work needed:
- Read and comply with GENERAL INFORMATION .
- Remove BRAKE BOOSTER .
Disconnect plug connection (1) on clutch master cylinder.
Disconnect line connection (2).
IMPORTANT:
Catch brake fluid in a suitable container.
Disconnect plug connection (1) on brake light switch.
Undo nut (2) and remove bearing bracket (3).
Installation note:
Tightening torque 35 11 1AZ .
Installation:
IMPORTANT:
If required the clutch pedal must be remounted depending on the version of the new bearing block!
This operation is described in: REMOVING AND INSTALLING CLUTCH PEDAL
Install bearing bracket (3).
Fit nut (2) and tighten.
Replace self-locking nuts.
Parts: Nut
Tightening torque 35 11 1AZ .
Connect plug connection (1) on brake light switch.
Connect line connection (2).
Connect plug connection (1) on clutch master cylinder.
Required follow-up work:
- Install the BRAKE BOOSTER .
- Vent the CLUTCH AND BRAKE HYDRAULICS .