22 11 001 Replacing right engine mount (B46, B48)

Necessary preliminary tasks: 

• Draw off A/C SYSTEM .
• Remove RIGHT HEADLIGHT .
• Remove SERVOMOTOR for eccentric shaft.
• Remove front UNDERBODY PROTECTION .
• Remove front right WHEEL ARCH PANEL .
• Support engine with jack.

Removal: 

Release screw (2) and expanding rivet (1). Loosen screws (3).

Remove upper and lower partition wall.

Fig 1: Upper And Lower Partition Wall Screw And Expanding Rivet Location

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and disconnect refrigerant line.

Fig 2: Refrigerant Line Screw Location

Courtesy of BMW OF NORTH AMERICA, INC.

Remove refrigerant line from holder (1).

Detach holder (2) for refrigerant line.

Release screws (3) and screws (4).

Fig 3: Refrigerant Line Holder And Screws Location

Courtesy of BMW OF NORTH AMERICA, INC.

Remove engine mount.

Installation: 

Install engine mount.

Tighten screws (3) and screws (4).

Parts:  Replace screws (4).

Tightening torque 22 11 1/2AZ .

Tighten holder (2) for refrigerant line.

Clip refrigerant line into holder (1).

Fig 4: Refrigerant Line Holder And Screws Location

Courtesy of BMW OF NORTH AMERICA, INC.

Join refrigerant line and tighten screw (1).

Fig 5: Refrigerant Line Screw Location

Courtesy of BMW OF NORTH AMERICA, INC.

Install upper and lower partition wall.

Tighten down screws (3).

Tighten screw (2) and secure expanding rivet (1).

Fig 6: Upper And Lower Partition Wall Screw And Expanding Rivet Location

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Remove jack from below engine.
• Install the front right WHEEL ARCH PANEL .
• Install front UNDERBODY PROTECTION .
• Install the SERVOMOTOR for the eccentric shaft (B48).
• Fill A/C SYSTEM .
• Install the RIGHT HEADLIGHT .
• Install the CROSS CONNECTION (B47).