Removing and installing rear (EDC) support bearing for shock absorber (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 0 040

Preliminary work needed:

Remove REAR SHOCK ABSORBER .

Removal:

Release adapter plate (2) from support bearing.

Disconnect connector (1) from shock absorber.

Remove adapter plate (2).

G11648680

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) with special tool 33 0 040, reversible ratchet with extension and socket SW10.

Remove spring strut mounting (2).

Impact screwdrivers are prohibited!

Risk of damage inside the shock absorber!

G11648681

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit support bearing (2).

Part: Replace nut (1).

Tighten down nut (1) with special tool 33 0 040, reversible ratchet with extension, socket SW10 and torque wrench with ring wrench attachment SW21.

Tightening torque 33 52 3AZ .

G11648685

Courtesy of BMW OF NORTH AMERICA, INC.

Impact screwdrivers are prohibited!

Risk of damage inside the shock absorber!

Installation note:

Make sure cable routing (1) is in the correct position. See figure!

G11648686

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) to shock absorber.

Fit adapter plate (2) on support bearing and engage.

G11648680

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install REAR SHOCK ABSORBER .