Adjusting rear axle (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 32 4 200
NOTE:
A camber change always means a track change as well. The camber must therefore be adjusted first.
If camber and toe-in are not adjustable within setpoint range: Troubleshooting at rear axle.
Adjusting camber:
Replace the eccentric screw (1) and nut and tighten to 5 Nm prior to setting.
Turn screw (1) and adjust camber to setpoint value.
Tighten nut (1).
Parts: replace nut.
Tightening torque 33 32 2AZ .
Adjusting track:
replace the screws (1) and (2) and tighten to 5 Nm prior to setting.
Mount special tool 32 4 200 on screw (2).
Turn special tool 32 4 200 and adjust toe-in to setpoint value.
Tighten down screws (1).
Tightening torque 33 32 5AZ .