LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2019 >> Cooper Clubman S ALL4, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Maintenance And General Information - Repair (F57)) >> 00 01 Safety Instructions, Notes On Using The Repair Instructions >> Symbols used and information in repair instructions (Cooper Convertible)

Symbols used and information in repair instructions (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Precautionary rules and measures which protect mechanics and other personnel against injury (including life-threatening injuries).

For example  :

WARNING: Risk of scalding! 

Only perform this work after engine has cooled down.

IMPORTANT: Specific instructions and precautionary measures which prevent damage to the vehicle or to vehicle parts. Failure to comply with the above will invalidate any warranty claims.

The caution symbol is used in all repair instructions.

However, use of the warning word "Caution!" is not binding in every case.

The notes, instructions and precautionary measures mentioned above retain their validity.

WARNING: High-voltage system - danger to life!
Before beginning work, follow the applicable safety rules and perform the necessary preliminary work.
NOTE: High-voltage symbol for hybrid cars (electrically powered vehicles) E72 and MINI E.
WARNING: High-voltage system - danger to life!
Before beginning work, follow the applicable safety rules and perform the necessary preliminary work.
NOTE: High-voltage symbol for hybrid car (electrically powered vehicle) from F04.
NOTE: Particular information on improved procedures for operation, testing, adjustment and upkeep.
Also indicates the end of a repair section.

Recycling: 

Observe country-specific waste disposal regulations

General information: 

Refers to other instructions: such as e.g.: 

Necessary preliminary tasks; 

Further instructions: refer to operating instructions for balancing machine.

Replacement  :

Carry out programming/coding.

NOTE: Many electronic control units must be programmed/coded (e.g. when replaced).
NOTE: (symbol for diagnostic system):
IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)! .
NOTE: Electronic control units and other electronic components - if handled incorrectly - can be damaged or destroyed by electrostatic discharge.

Special tools required: 

NOTE: List of special tools needed in these repair instructions.
IMPORTANT: Do not oil or grease component or tool.
NOTE: Oil and grease will impair or damage the function of the component or tool.
WARNING: Laser beam!

For example  :

Adjustment device emits laser beam. Do not look into the beam!

Note on laser class.

IMPORTANT: Use eye protection for the following operations.

For example  :

Gas can emerge spontaneously at high speed when the fuel supply line is released!

IMPORTANT: Use ear protection for the following operations.
IMPORTANT: Use eye protection and ear protection for the following operations.
IMPORTANT: Use face protection for the following operations.
IMPORTANT: Use protective gloves for the following operations.
Avoid skin contact.
IMPORTANT: Use eye protection and protective gloves for the following operations.
Avoid eye contact and skin contact.
WARNING: Danger of explosion! 

First aid measures: 

Note on first aid measures that need to be administered immediately.