Removing and installing/replacing the controller drive of the defroster flap
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work needed:
- Remove right GLOVE COMPARTMENT .
Removal:
Disengage and remove air duct (1) on heating and air-conditioning unit.
Unscrew the screws (1).
Unfasten plug connection (2) and disconnect.
Remove actuator drive (3).
Installation:
NOTE:
Make sure actuator drive (3) is correctly fitted.
Position actuator drive (3) correctly.
Join and lock plug connection (2).
Tighten down screws (1).
Position air duct (1) correctly and engage at heating and air-conditioning unit.
NOTE:
Ensure the air duct (1) is fitted correctly and securely.
Required reworking:
- Install right GLOVE COMPARTMENT .
IMPORTANT:
Servomotors must be readdressed in the event of replacement!
Addressing can only be carried out with the BMW diagnostic system.
Service functions:
- Body
- Heating/air conditioning function
- Flap motors
- Readdress flap motors