41 33 730 Replacing girder for left cross connection

Read contents of BODY, GENERAL .

Necessary preliminary tasks: 

• Remove CROSS CONNECTION .
• Remove the LEFT HEADLIGHT FIXTURE .

Removal: 

Lift out expanding rivet (1) and remove cover (2).

Fig 1: Expanding Rivet And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release expanding rivet (1) and clip (2).

Undo screw (3) and place cover (4) with hood seal to one side.

Release coupling (5) from support for cross connection.

Fig 2: Expanding Rivet, Clip, Cover, Screw, And Coupling

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 3: Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release 4 screws (1) and remove support (2) for cross connection.

Fig 4: Cross Connection Support And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Observe the "Procedure for front panel installation".

Install support (2) for cross connection. Fit all screws.

4 Tighten screws (1). Tightening torque 41 33 5AZ .

Fig 5: Cross Connection Support And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Tightening torque 41 33 4AZ .

Fig 6: Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Install cover (4) together with hood seal.

Tighten screw (3).

Attach expanding rivet (1) and clip (2).

Fit coupling (5) on CROSS CONNECTION  support.

Fig 7: Expanding Rivet, Clip, Cover, Screw, And Coupling

Courtesy of BMW OF NORTH AMERICA, INC.

Install cover (2) and secure with expanding rivet (1).

Fig 8: Expanding Rivet And Cover

Courtesy of BMW OF NORTH AMERICA, INC.