Removing and installing/replacing servodrive for fuel filler flap (Cooper Convertible)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work needed:

Remove COVER HOUSING .

Removal:

Unlock retaining lugs (2) with a suitable tool.

Remove actuator drive (1) from cover pot (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Release the actuator drive (2) by simultaneously turning and pressing the locking pin (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Engage actuator drive (2) at locking pin (1).

NOTE: Make sure the setting for the controller drive (2) for the gas cap is correct. It must be possible to lock or unlock the gas cap completely.

Courtesy of BMW OF NORTH AMERICA, INC.

Correctly position actuator drive (1) and engage in cover housing (3).

NOTE: Retaining lugs (2) must not be damaged or missing.

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking:

Install COVER HOUSING .