REP-TAT-P-5218-02 Install front seat
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Pyrotechnic components.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: NOTES airbag safety regulations!
WARNING:
Airbag unit.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before performing any work on the airbag, always disconnect the battery ground lead from the battery.
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
- For additional information see: NOTES airbag safety regulations!
Removing the front seat from the universal seat mount
- Remove front seat
(1) from the special tool 2 154 711
(1.)
NOTE:
RISK OF DAMAGE
Scratches.
Tools and sharp-edged components can cause scratches.
Scratches.
Tools and sharp-edged components can cause scratches.
- Protect working area.
- Handle tools and components carefully.
- Cover the door sill using protective covers.
NOTE:
RISK OF DAMAGE
Heavy component.
Heavy components can lead to injury or damage.
Heavy component.
Heavy components can lead to injury or damage.
- Remove and install heavy components with the aid of another person/other persons.
- With the assistance of another, lift the front seat into the vehicle and position.
- Place front seat to the rear and connect the connector (1).
- Adjust the front seat to the rear.
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).
Tightening torques
TIGHTENING TORQUE SPECIFICATION
| M10 Replace screw. |
tightening torque 42 Nm |
- Adjust front seat forward.
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).
Tightening torques
TIGHTENING TORQUE SPECIFICATION
| M10 Replace screw. |
tightening torque 42 Nm |
Disconnecting all battery ground leads
Further information is available.
- See: BATTERY GROUND LEAD.