51 45 435 Removing and installing/replacing cover for instruments

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Removal:

Press in the pin (1) from the clips (2) a maximum of 2.5 mm, up to the first latch mechanism.

Remove the clips (2).

Fig 1: Pin And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The cover (1) must only be slightly raised from the bottom, otherwise there is the danger that the fibre-optic conductor will break.

Raise the cover (1) bottom from the latch mechanism (dimension X: maximum of 8 mm).

Maintain the position of the cover (1).

Fig 2: Cover Position Dimension

Courtesy of BMW OF NORTH AMERICA, INC.

Press the cover (1) together on the positions (2 and 3) with both palms.

Tightly grip the cover (1) in this position and rotate it counter clockwise, until the latch mechanism releases.

Remove the cover (1) towards the rear.

Fig 3: Cover Pressing Position

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Engage the cover (1) and mount the clips (2).

Fig 4: Cover And Clips

Courtesy of BMW OF NORTH AMERICA, INC.