51 23 265 Removing and installing/replacing left or right gas pressure spring for engine compartment lid
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of injury!
Use suitable tool to support bonnet in the fully opened position.
Removal:
Make a written record of the installation position of the gas pressure springs before removing.
If necessary, release cable clip on gas pressure spring (2).
Slide retaining spring (1) to end of gas pressure spring (2) and lift of gas pressure spring (2) from ball head.
Repeat procedure at other end of gas strut (2).
Installation:
Slide retaining spring (1) back into initial position.
Press the gas pressure spring (2) onto the ball pins on the vehicle at the top and bottom end.
Gas pressure spring (2) must be felt to engage.