Removing and installing/replacing control unit/module for seat heating (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with NOTES on protection against electrostatic discharge (ESD protection).
Removal:
NOTE:
To facilitate installation/removal of control unit, shift seat upwards and to the rear fully.
Disconnect all connectors (1).
Press control unit/module for seat heating (2) first in arrow direction (4) and then simultaneously in arrow direction (5) and feed out of the plastic holder (3).
Installation:
Feed control unit/module for seat heating (2) into the plastic holder (3) first in arrow direction (4) and then engage in arrow direction (5).
Connect all connectors (1).
NOTE:
Make sure control unit/module for seat heating (2) is correctly engaged.