REP-TAT-P-5175-02 Installing undershield on right
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Position the undershield (1) correctly.
- Tighten all bolts and nuts (arrows).
TIGHTENING TORQUE SPECIFICATION
| Undershield, side | |
|---|---|
| Plastic nut | |
| Tightening torque | |
| 2.6 Nm | |
TIGHTENING TORQUE SPECIFICATION
| Undershield, side | |
|---|---|
| Hexagon screw | |
| Tightening torque | |
| 2.6 Nm | |
- replace screws (1). Parts: screw
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATION
| Torsion strut to mounting | |
|---|---|
| Hexagon screw M12x48 Replace screws | |
| Joining torque | |
| 100 Nm | |
| Angle of rotation | |
| 90° | |
| Torx screw M10x16 | |
| Tightening torque | |
| 38 Nm | |
Install RIGHT TENSION STRUT
Install TRAILING LINK
- Position tension strut (3).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATION
| Torsion strut to front axle/body, middle | |
|---|---|
| M10 | |
| Joining torque | |
| 56 Nm | |
| Angle of rotation | |
| 90° | |
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATION
| Torsion strut to side member | |
|---|---|
| M12 | |
| Joining torque | |
| 100 Nm | |
| Angle of rotation | |
| 70° | |