Removing and installing rear bumper panel (Cooper Convertible)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Paint damage.
Mechanical action can lead to paint damage.
Paint damage.
Mechanical action can lead to paint damage.
- Mask those working areas at risk with yellow plastic adhesive tape.
- Remove and install heavy or bulky components with the aid of another person/other persons.
NOTE:
TECHNICAL INFORMATION
Notes for the gap dimensions of the body form the basis of this REP and it is mandatory to observe them.
For additional information see: GAP DIMENSIONS, BODY
Notes for the gap dimensions of the body form the basis of this REP and it is mandatory to observe them.
For additional information see: GAP DIMENSIONS, BODY
Preliminary work needed:
- Remove WHEEL HOUSING PLATES from bumper cover
- Remove TAIL LIGHTS .
Removal:
Release left and right screws (1).
Unscrew the screws (1).
Release bumper cover (1) from detents in marked areas (2).
Disconnect plug connections for rear fog light/ultrasonic sensor.
Remove bumper cover (1) with a second person helping.
Installation:
Position bumper cover (1) with the aid of a second person.
Connect plug connections for rear fog light/ultrasonic sensor.
Clip in bumper cover (1) in detents in marked areas (2).
Tighten down screws (1).
Tighten screws (1) on left and right.
Tightening torque 51 12 3AZ .
Required follow-up work:
- Install WHEEL HOUSING PANELS .
- Install TAIL LIGHTS .
- Adjust gap dimension on bumper cover