Removing and installing/replacing clutch master cylinder (Cooper)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2021 MINI Cooper, 2020 MINI Cooper, 2019 MINI Cooper, 2018 MINI Cooper, and 2017 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work needed:

Remove BEARING BRACKET for foot pedal.

Removal:

Press pin (1) together and press out.

Release nuts (2) and remove clutch master cylinder.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert bolt (1).

Install clutch master cylinder and tighten nuts (2).

Tightening torque 21 52 2AZ .

IMPORTANT: After completing work vent clutch hydraulic system.

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking:

Install BEARING BRACKET for foot pedal.