67 11 555 Removing and installing/replacing servodrive for fuel filler flap

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove COVER HOUSING

Removal:

Unlock retaining lugs (2) with a suitable tool.

Remove actuator drive (1) from cover pot (3).

Fig 1: Locating Actuator Drive Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.

Release the actuator drive (2) by simultaneously turning and pressing the locking pin (1).

Fig 2: Locating Actuator Drive Locking Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Engage actuator drive (2) at locking pin (1).

NOTE: Make sure the setting for the controller drive (2) for the fuel filler cap is correct. It must be possible to lock or unlock the fuel filler cap completely.

Fig 3: Locating Actuator Drive Locking Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Correctly position actuator drive (1) and engage in cover housing (3).

NOTE: Retaining lugs (2) must not be damaged or missing.

Fig 4: Locating Actuator Drive Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking:

Install COVER HOUSING