52 26 022 Removing and installing/replacing striker for left or right rear seat backrest

WARNING: This page is about a different car, the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Microencapsulated screws must be coated with Loctite if they are to be reused
Screw connection must be completed within 20 min. (start of hardening)
Microencapsulated screws must not be retightened.
Thread of nut must be cleaned beforehand in event of repeated use

Preliminary work needed:

Remove TRUNK WHEEL ARCH PANEL
Fold backrest

Removal:

Unscrew the screws (1).

Remove striker (2).

Fig 1: Removing Striker

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Position striker (2).

Tighten down screws (1).

Tightening torque 52 26 3AZ .

Fig 2: Removing Striker

Courtesy of BMW OF NORTH AMERICA, INC.