Replacing roller bearing for dual-mass flywheel (B38 engine) (Cooper Clubman base)

Special tools required: 

• 21 2 050

Preliminary work needed: 

• Remove FLYWHEEL .

Using a hydraulic press (1) and special tool 21 2 050/51, press the roller bearing out of the dual-mass flywheel downwards on engine side.

Roller bearing must not be driven out.

Courtesy of BMW OF NORTH AMERICA, INC.

Push the roller bearing (2) onto special tool 21 2 050/52.

Using hydraulic press (1), press roller bearing into dual-mass flywheel to stop on clutch side.

Observe press-in instruction:

Courtesy of BMW OF NORTH AMERICA, INC.

• Roller bearing must not be driven in.
• Roller bearing mounting force/travel monitored:

  Min. 2000 N  1 mm before end of pressing in.

  Max. 15, 000 N  during entire press-in procedure.

  Required follow-up work: 

• Installing the FLYWHEEL .