Removing and installing (replacing) the top sensor line for contactless trunk opening replace

Attention! 

Observe the INFORMATION  on protection from electrostatic discharge.

Preliminary work needed: 

• Remove REAR BUMPER PANEL .

Removal: 

Unlock and disconnect the connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Release the cable from holders (1).

Release fixtures (2).

Remove the sensor line (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Position the sensor line (3).

Secure the clips (2).

Fasten the cable at the holders (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Connect the connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install REAR BUMPER PANEL .