Removing and installing head-up display (Cooper)

Attention! 

Observe the INFORMATION on protection from electrostatic discharge.

Attention! 

Comply with NOTES on handling optical fibers.

Risk of damage!

Do not hold the Head-Up Display by the heat sink.

If possible, do not touch the sound insulation on the Head-Up Display.

Do not touch the glass pane of the Head-Up

Display if possible.

Preliminary work needed: 

• Remove INSTRUMENT PANEL TRIM .

Removal: 

Loosen screws.

Carefully feed Head-Up Display (1) out of support (2) towards top.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) on underside of head-up display (2) and disconnect.

Remove head-up display (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Connect connector (1) on underside of head-up display (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Join Head-Up Display (1) with support (2).

Tighten the screws.

Tightening torque 62 30 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install INSTRUMENT PANEL TRIM .