Replacing crankshaft pulse sensor (B36, B38, B46, B48) (Cooper)

IMPORTANT: Read and comply with NOTES on protection against electrostatic discharge (ESD protection)!

Preliminary work needed:

Removal:

Unlock plug (2) from pulse generator and detach.

Remove screw (1).

Remove pulse generator (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install pulse sensor (3).

Tighten screw (1).

Tightening torque 13 62 2AZ .

Attach connector (2) on pulse sensor.

Connector (2) must snap audibly into place.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: