Replacing right engine mount (Cooper Clubman S and JCW)

Preliminary work needed: 

• Draw off A/C SYSTEM .
• Remove the CROSS CONNECTION (if installed).
• Remove RIGHT HEADLIGHT .
• Remove SERVOMOTOR for eccentric shaft.
• Remove FRONT UNDERBODY PROTECTION .
• Remove front right WHEEL ARCH PANEL .
• Support engine with jack.

Removal: 

Release screw (2) and expanding rivet (1).

Loosen screws (3).

Remove upper and lower partition wall.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and disconnect refrigerant line.

Courtesy of BMW OF NORTH AMERICA, INC.

Remove refrigerant line from holder (1).

Detach holder (2) for refrigerant line.

Release screws (3) and screws (4).

Remove engine mount.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Install engine mount.

Tighten screws (3) and screws (4).

Parts:  Replace screws (4).

Tightening torque 22 11 1/2AZ .

Tighten holder (2) for refrigerant line.

Clip refrigerant line into holder (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Join refrigerant line and tighten screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Install upper and lower partition wall.

Tighten down screws (3).

Tighten screw (2) and secure expanding rivet (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Remove jack from below engine.
• Install the front right WHEEL ARCH PANEL .
• Install FRONT UNDERBODY PROTECTION .
• Install the SERVOMOTOR for the eccentric shaft.
• Fill A/C SYSTEM .
• Install the RIGHT HEADLIGHT .
• Install the CROSS CONNECTION (if installed).