11 78 510 Removing and installing/replacing control sensor (B36A/B38A)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

11 7 020

WARNING: Risk of burning!

Only perform these tasks after exhaust system has cooled down.

Necessary preliminary tasks:

Remove CLEAN AIR PIPE

Removal:

Unclip connector (1) of control sensor from holder.

Unlock and disconnect the connector (1) of the control sensor.

Fig 1: Locating Connector Of Control Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Release cable of control sensor from bracket (1).

Fig 2: Control Sensor Cable Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Release control sensor (1) with special tool 11 7 020 .

Fig 3: Releasing Control Sensor With Special Tool (11 7 020)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Installation note:

If an oxygen sensor is reused, thinly and evenly coat only the thread with use NEVER-SEEZ COMPOUND (4.3) .

The part of the oxygen control sensor which projects into the exhaust branch (sensor ceramic) must not be cleaned or come into contact with lubricant.

Screw in control sensor (1) and tighten with special tool 11 7 020 .

Tightening torque: 11 78 1AZ .

Fig 4: Releasing Control Sensor With Special Tool (11 7 020)

Courtesy of BMW OF NORTH AMERICA, INC.

Clip cable of control sensor into holder (1).

Fig 5: Control Sensor Cable Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) of control sensor and clip into holder.

Fig 6: Locating Connector Of Control Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Check function of DME.