REP-TAT-P-5218-02 Install backrest frame
- Correctly position the rear seat backrest (5).
If necessary, feed in relative cables.
NOTE:
Perform the steps on the right and left side.
- Tighten the screws (4).
Tightening torques
TIGHTENING TORQUE SPECIFICATION
| Screw Replace screw. |
tightening torque 38 Nm |
- F56/57:
Correctly attach cable linkage (1) in holders (2) and (3).
Required follow-up work
Install FRONT SEAT
Install INNER COVER
Install the COVER for backrest adjustment
Install the STEERING LEVER for backrest adjustment
Install the LEVER for seat height adjustment
Install the OUTER COVER on the front seat
Install the THIGH SUPPORT on the front seat
Install SEAT COVER WITH CUSHION
Install the SEAT FRAME
Install FRONT SEAT
Install TRIM for backrest release
Install the REAR PANEL from the front seat backrest
Install the TRIM at the bottom of the aperture
Install SIDE AIRBAG from front seat
Install the BACKREST COVER with the cushion