51 16 366 Removing and installing/replacing right glove box with housing

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Necessary preliminary tasks:

Removal:

Pull out covers (1) and release the underlying screws (2).

Fig 1: Covers And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove glove box (2) inwards and disconnect associated plug connections.

Fig 2: Glove Box And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

When replacing, swap over the following parts:

Connect associated connector and connect air hose if required.

Insert glove box (2) and tighten with screws (1).

Fig 3: Glove Box And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (2).

Clip in the covers (1).

Fig 4: Covers And Screws

Courtesy of BMW OF NORTH AMERICA, INC.