51 16 165 Removing and installing/replacing complete center console

Necessary preliminary tasks:

Remove left and right SIDE CENTER CONSOLE TRIM PANEL
Remove REAR CUP HOLDER
Remove DSC CONTROL UNIT
Release and remove the gaiter for parking brake lever from the center console
Only for version with center armrest:
Remove CENTER ARMREST
With controller version only:
Remove CONTROLLER

Removal:

Release screws (1).

Additionally for version with center armrest:

Release screw (2).

Additionally for version with controller:

Release screw (3) and take out connector (4).

Fig 1: Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release left and right screws (1).

Fig 2: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Raise center console (1) at the rear and take out selector lever or gearshift lever (2) and gaiter (3).

Remove center console (1) to the rear/top.

Fig 3: Removing Center Console

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Feed in center console (1).

Fig 4: Installing Center Console

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screws (1) on left and right.

Tightening torque 51 16 1AZ .

Fig 5: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Tightening torque 51 16 6AZ .

Additionally for version with center armrest:

Tighten screw (2).

Tightening torque 51 16 6AZ .

Additionally for version with controller:

Connect the connector (4) and tighten the screw (3).

Tightening torque 51 16 6AZ .

Fig 6: Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.