51 23 212 Removing and installing/replacing cable for engine compartment lock, front (in passenger compartment)

Necessary preliminary tasks:

Removal:

Disengage cable (1) at lever (2).

If necessary, detach the traction (1) from the clips to the bulkhead.

Fig 1: Cable And Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Lift and open the clutch (1) from the door lock support (2).

Disengage cable (3).

Fig 2: Lock Support, Coupling And Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Version 1:

Detach cable (1) from holder (2).

Feed out cable (1) with grommet (3) out of bulkhead.

Fig 3: Grommet, Cable And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Version 2 with shorter Bowden cable:

Feed out cable (1) with grommet (2) out of bulkhead.

Fig 4: Cable And Grommet

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Version 1:

Feed in cable (1) with grommet (3) into bulkhead.

Attach cable (1) in holder (2).

Fig 5: Grommet, Cable And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Ensure grommet (3) is correctly fitted on bulkhead.

Version 2 with shorter Bowden cable:

Feed in cable (1) with grommet (2) into bulkhead.

NOTE: Make sure the traction (1) is positioned correctly, traction (1) runs over spring strut dome.

Fig 6: Cable And Grommet

Courtesy of BMW OF NORTH AMERICA, INC.

Version 2 with shorter Bowden cable (RHD):

NOTE: Cable (1) must fit correctly in clamp (2).

Fig 7: Cable And Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Attach cable (3).

Clip in and close the clutch (1) into the door lock support (2).

Fig 8: Lock Support, Coupling And Cable

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, attach the traction (1) from the clips to the bulkhead.

Attach cable (1) on lever (2).

Fig 9: Cable And Lever

Courtesy of BMW OF NORTH AMERICA, INC.