51 11 158 Replacing base plate for number/license plate: Notes
Only use the vehicle-specific number plate baseplate.
The installation of other license plate baseplates is not permissible.
Refer to LICENSE PLATE ATTACHMENT AT FRONT .
The number plate must be precisely mounted on the number plate baseplate.
If a number plate baseplate is not offered for the corresponding national-market version, the number plate must be screwed directly onto the bumper using a drilling template.
Incorrect assembly leads to a malfunction of the sensors of the driver assist systems.
NOTE:
Schematic diagram shown on example of F56 Cooper S national-market version USA.
There may be differences in detail in the case of other versions.
Removal:
Release screws (1).
Remove holder (2) towards front.
Installation:
Position support (2).
Tighten down screws (1).
NOTE:
For initial installation on new bumper panel, pre-drill marks on bumper.