REP-TAT-P-5434-02 Install the gasket in front

Follow-up work 

• Install/adjust the SEAL  of the roof frame
• Install the TRIM PANEL  for the guide rail

• Coat the seal (1) with mounting agent.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Place the end piece of the seal (1) onto the joint at the back of the frame (2) and secure it approximately 5 cm toward the front.
• Place the end piece of the seal (1) onto the joint at the front of the frame (2) and secure it approximately 5 cm toward the back.

  Courtesy of BMW OF NORTH AMERICA, INC.

• First, apply slight pressure from the right and left toward the center to latch the top and then the bottom section (1).
• Check gasket for correct fit.

Courtesy of BMW OF NORTH AMERICA, INC.