51 14 110 Removing and installing/replacing rear model designation

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The INSTRUCTIONS FOR ADHERING BADGE EMBLEM serve as the basis for these repair instructions and must be followed without fail.

Installation dimensions:

Fig 1: Identifying Positions For Marking With Adhesive Tape

Courtesy of BMW OF NORTH AMERICA, INC.

Mark position of model designation with adhesive tape using dimensions (A and B).

Position model designation on mark and stick on.

	A	B
Cooper	328 mm	52 mm
Cooper S	328 mm	64 mm
Cooper D	328 mm	73 mm
Cooper SD	328 mm	64 mm

Fig 2: Identifying Positions For Marking With Adhesive Tape

Courtesy of BMW OF NORTH AMERICA, INC.

Mark position of model designation with adhesive tape using dimensions (A to C).

Position model designation on mark and stick on.

A	300 mm
B	194 mm
C	290 mm