51 14 002 Removing and installing/replacing front MINI badge
WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
The INSTRUCTIONS on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.
NOTE:
The MINI badge is damaged when removed and must be replaced.
Removing badge:
Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322 .
Fitting badge:
Pull liner* off adhesive tape (1), position badge over guide pins (2) on hood/bonnet and press down firmly.
* Liner is the protective film on a new plate.
Special tools required:
IMPORTANT:
The INSTRUCTIONS on component bonding with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.
NOTE:
The MINI badge is damaged during disassembly and must be replaced.
Removal:
Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322 .
Installation:
Pull off the Liner* from the adhesive tape (1) and place the MINI badge over the guide pines (2) on the Front compartment lid and press down firmly.
* Liner is the protective film on a new MINI badge.