11 36 655 Removing and installing/replacing both solenoid valves (N18)

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Always check that the solenoid valves are clean during removal and installation.
Possible malfunction if there is dirt contamination in the valves:

Irregular operation.
OBD fault entry.
Exhaust emission behavior.
Low engine performance.

Necessary preliminary tasks:

Remove ACOUSTIC COVER

NOTE: Illustration shows intake valve.

Disconnect plug connection on solenoid valve (3).

Release screw (1).

Remove solenoid valve (2).

Fig 1: Identifying Plug Connection, Solenoid Valve And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace sealing rings on solenoid valve.

Fig 2: Identifying Sealing Rings On Solenoid Valves

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Check function of DME.