11 78 610 Removing and installing/replacing lambda monitor sensors (N16)
WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 11 7 030
- 11 9 150
WARNING:
Risk of burning!
Only perform these tasks after the exhaust system has cooled down.
Only perform these tasks after the exhaust system has cooled down.
Necessary preliminary tasks:
- Read fault memory.
Installation note:
If an oxygen sensor is to be reused, only apply a thin and uniform coat of Never Seez Compound to thread.
The part of the oxygen monitoring sensor which projects into the exhaust system branch (sensor ceramic) must not be cleaned or come into contact with lubricant.
Disconnect plug connection for oxygen monitoring sensor.
Release monitoring sensor (1) with special tools 11 7 030 and 11 9 150.
Tightening torque: 11 78 1AZ .
Assemble engine.
Check function of Digital Engine Electronics.