11 12 729 Checking cylinder head for water leaks (N18)

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary tasks:

Remove CYLINDER HEAD .
Disassemble cylinder head. See REMOVING INTAKE CAMSHAFT and REMOVING EXHAUST CAMSHAFT .

Extend special tool 11 9 521 with special tool 11 9 523 .

Installation note:

Assembly special tool 11 9 521 so that all water channels are sealed.

Fig 1: Identifying Special Tool (11 9 521)

Courtesy of BMW OF NORTH AMERICA, INC.

Fix special tool 11 9 523 by tightening to 25 Nm .

Fig 2: Identifying Special Tool (11 9 523)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: For the N18 engine, the special tool 11 9 522 must be modified.

Dimension (A) 15 mm, dimension (B) 79.85 mm.

Both dimensions have to be transferred to special tool 11 9 522 .

Fig 3: Identifying Special Tool Modification Dimensions

Courtesy of BMW OF NORTH AMERICA, INC.

Using a suitable tool, cut off the top corner along the dotted line.

Screw special tool 11 9 522 into place with existing screws (1 and 3) of coolant thermostat.

Sealing flange must rest flat.

NOTE: Compressed air on valve (2) maximum 3 bar .

Heat cylinder head to 60 °.

Visual inspection in a water bath.

Fig 4: Identifying Special Tool (11 9 522) And Existing Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Illustration shows (N12).

Assemble engine.