65 75 055 Removing and installing/replacing emergency power siren with tilt sensor

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove REAR RIGHT WHEEL ARCH COVER

Unscrew nuts (1).

Tightening torque 65 75 3AZ .

Remove holder (2) with emergency power siren.

Fig 1: Identifying Emergency Power Siren Holder And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Release cable fixation.

Remove the holder (3) with emergency power siren.

Replacement:

Slacken nut (2).

Remove emergency power siren (3) from holder.

Tightening torque 65 75 2AZ .

Installation note:

Make sure tilt alarm sensor is correctly seated in holder (2).

Fig 2: Identifying Emergency Power Siren Holder, Nut, And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/ENCODING .