12 14 523 Replacing pulse sensor on intake camshaft (N16)

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Switch off ignition.
Read out fault memory of DME control unit.
Check stored fault messages.

Unlock connector (1) and remove.

Loosen the screw and remove the pulse sensor (2).

Installation note:

Replace sealing ring and coat with lubricant.

Tightening torque 13 62 4AZ .

Fig 1: Locating Pulse Sensor Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Delete fault memory.