12 14 521 Replacing crankshaft pulse sensor (N18)

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Switch off ignition.
Read out the fault memory of the DME control unit.
Remove transfer box.

NOTE: For a better overview, the following operation is shown on the engine after it has been removed.

Remove cover (1).

Fig 1: Identifying Crankshaft Pulse Sensor Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Release screw and remove pulse sensor.

Tightening torque 13 62 3AZ .

Fig 2: Locating Crankshaft Pulse Sensor Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.

Delete fault memory.