24 35 508 Replacing wiring harness in automatic transmission (AISIN)
WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After completion of work, check TRANSMISSION OIL LEVEL
.
Make a note of drained ATF quantity.
Required replenishment quantity approx. 4.5 liters.
Make a note of drained ATF quantity.
Required replenishment quantity approx. 4.5 liters.
IMPORTANT:
Use only the approved AUTOMATIC TRANSMISSION OIL
in this transmission.
Otherwise the automatic transmission may incur extensive damage!
Do not drain oil before the transmission has cooled down.
Otherwise the automatic transmission may incur extensive damage!
Do not drain oil before the transmission has cooled down.
Necessary preliminary tasks:
- Remove HYDRAULIC SHIFT UNIT
Release screw (1).
Disconnect multiple pin connector (2) of EGS control unit.
Tightening torque: 24 11 19AZ .
Installation note:
Coat O-ring with ATF.
Release screw (1).
Disconnect multiple pin connector (2) of EGS control unit.
Tightening torque: 24 11 19AZ .
Installation note:
Coat O-ring with ATF.