24 00 051 Installing an exchange transmission (AISIN)
WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Transmissions are filled with fluid. Oil level does not have to be compensated!
Only in the event of discernible external damage to exchange transmission or discernible oil leakage from exchange transmission - check OIL LEVEL .
Only in the event of discernible external damage to exchange transmission or discernible oil leakage from exchange transmission - check OIL LEVEL .
After completing work:
- Use only the approved AUTOMATIC TRANSMISSION OIL .
- Reset adaptation values.
- Perform clutch and gear ratio adaptation.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations
Necessary preliminary tasks:
- Remove transmission (no wheel alignment required). See REMOVING/INSTALLING TRANSMISSION or REMOVING/INSTALLING TRANSMISSION (ALL-WHEEL DRIVE, N18) .
Convert following components from previous transmission to new transmission.
- Converter, transportation retainer (1).
- Holder with retaining clips for wiring harness
- Modify ventilation pipe
- Transportation plate
- Transmission carrier with transmission support block
Tightening torque 24 11 9AZ .