24 10 018 Adjusting selector lever (AISIN)

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: An incorrectly adjusted gearshift mechanism can result in tooth meshing noises be transmitted into the passenger compartment.

Necessary preliminary work:

Remove intake silencer housing. See REMOVING INTAKE SILENCER HOUSING (N16) or REMOVING INTAKE SILENCER HOUSING (N18) .
Remove intake silencer housing gaiter.
Move selector lever into "P" position.

Insert the end of the gear selector cable into the locating sleeve (1) of selector lever.

Insert gear selector cable in holder.

Secure gear selector cable with clip to retaining bracket (2).

Move selector lever to "P" position (in counter-clockwise direction).

Fig 1: Identifying Sleeve And Retaining Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Grip nut (1) and tighten down nut (2).

NOTE: Press against end of gear selector cable shortly before tightening down screw.

Tightening torque 24 11 8AZ .

NOTE: Graphic similar.

Fig 2: Identifying Nuts

Courtesy of BMW OF NORTH AMERICA, INC.