31 35 021 Replacing both rubber mounts for stabilizer mounting on front axle support
WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Release ANTI-ROLL BAR at holder for wishbone.
IMPORTANT:
Circo Light must not
be used between anti-roll bar and rubber mount!
Remove retaining brackets (1).
Remove rubber mount (2) from stabilizer (2).
Installation note:
Keep anti-roll bar clean and free of oil and grease.
Make sure rubber mount (2) is correctly engaged on locating ring (3).
To install retaining bracket (1), coat rubber mount with Circo Light (obtainable via BMW/MINI).