13 62 010 Removing and installing/replacing fuel differential-pressure sensor (N16)

WARNING: This page is about a different car, the 2016 MINI Cooper Paceman, 2015 MINI Cooper Paceman, 2014 MINI Cooper Paceman, and 2013 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove INTAKE SILENCER HOUSING .
Installation location: On intake plenum, left side.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Unlock connector (1) and remove.

Release screw.

Pull fuel differential-pressure sensor (2) out of intake plenum.

Installation note:

Check sealing ring, replace if necessary.
Tightening torque 13 62 1AZ .

Fig 1: Identifying Fuel Differential-Pressure Sensor, Screw, And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check stored fault messages.

Delete fault memory.